Tanning Bulbs

Tanning bed lamps are located in every sun bed or suntan lamp in the shops. When you are purchasing a new or especially a used suntan bed, make a good examination of the bulbs. Make sure that they are real tanning bulbs and comply with the FDA regulations with regard to health and safety. You should also consider how difficult it is to get at the bulbs. Be sure that the bulbs are easy to change when necessary. It is quite important, and a lot cheaper, if you can perform such simple maintenance yourself, if you buy a home sun bed.

There are two very different, non-interchangeable kinds of bulbs used in conventional and high pressure beds. You need to ensure you buy the right tanning bed bulbs for your sun bed, because you cannot use just any lamp you like. If you are buying replacement bulbs on the Internet, check the make and model of your existing bed very carefully, because you have to ensure that the bulbs you are buying are suitable for your bed.

High Pressure Sunbed Bulbs: high pressure beds use quartz lamps in various sizes. The gases used in these bulbs are pressurized to slightly higher than atmospheric pressure. The bulbs in these beds are located in the hood of the bed, so that you tan from above only. When you have tanned the skin on one side of your body for about 10-12 minutes, you turn over and tan the other side. The flat bed of these devices is much more comfortable than a conventional sun bed.

The biggest benefit of these lamps is the amount of time you need to spend on the sun bed. Because you tan faster, you need to spend less time in the salon, which means it works out cheaper. You can get the level of tan you want in about three weeks of three to five sessions a week. However, with a conventional bed, it would take you at least a month to achieve the same level of colour. Maintaining your tan is much easier too. You only need two or three sessions a month to maintain the colour, compared with four times that many sessions on a low pressure bed. Many of these bulbs use UVA rays only, not UVB rays which are responsible for burning.

Conventional Sun Bed Lamps: Conventional, or low pressure beds use long tube lamps that resemble household fluorescent tubes. The lamps are located in the top and the bottom of the sun bed, which means that all the body parts are tanned at the together, without needing to roll over during the tanning session.

Low pressure beds use UVA and UVB rays in varying levels. Some use both rays and others emit mostly UVA with some UVB rays. UVA rays are responsible for the (premature) ageing effects on the skin and UVB rays are the burning rays that cause sun burn when you are outside in the sun. It is very important to discover which type of rays your sun bed's bulbs emit. You must ensure you replace your existing bulbs with the same new lamps after about 1,000 hours of use.

Something else to think about when selecting the type of bed you use at home or in the salon, is the tanning bed lotion you will use. Different lotions suit different sorts of beds. The owner of your tanning salon will be able to help you select a lotion that will be best for the bed you are using and your skin type. No matter what bed you use, you ought to certainly always use a lotion or a cream, because they will moisturise your skin and help you get a Hollywood tan more quickly.

Article Source: http://searchmybox.com

Do you need to discover more about tanning bed bulbs? If so, just visit our website on tanning bed bulbs This and other unique content '' articles are available with free reprint rights.

Please Rate this Article

5 out of 54 out of 53 out of 52 out of 51 out of 5 

Not yet Rated